“SAW components (surface acoustic wave components), integrated radio frequency modules are key components of modern information and communications.”
TDK Corporation has extended its range of EPCOS power factor controllers. The new BR7000-I controller is designed specifically for single-phase networks and combines all the performance features and functions of the proven BR6000 series with the benefits of the BR7000 controller.
The controller has 12 or 13 outputs. The message and alarm relay parameters may be programmed to open or close.
“Polar and nonpolar aluminum electrolytic capacitors ranging up to 1.5 Farads and up to 500 VDC in sizes from 3/4″ diameter to 3.5″ diameter and 9” long.
“Mechanically tuned variable inductors for VHF and UHF applications. They are made in up to 8-gang configurations and are tuned using a common rotary shaft moving contacts along single turn or or spiral silver coils.”
Sensitron is a privately held company, founded in 1969 and located on Long Island in Deer Park, New York. Products include motor controllers, diodes, smart power management and conversion, voltage protection components and embedded boards
Tyco Electronics designs, manufactures and markets engineered electronic components, these are passive electronic components which include connectors and interconnect systems, relays, switches, circuit protection devices, touchscreens, sensors, and wire and cable.
Rugged Fiber Optics enable data delivery at high speed and over long distance to a level not possible with traditional copper cable…
TE’s ASIC (application-specific integrated circuit) to ASIC end-to-end solutions include a comprehensive range of connectors, cables, Optical Flex Circuitry, routers, switches, passive, active and electro optic devices
SuperDrum integrated reels, which integrate cables, connectors, and media conversion.
TE AD&M Fiber Optics Product & Application Summary
This product solution set employs electro optic devices such as switch / routers inclusive of Wavelength Division Multiplexing, active devices, as well as harness and interconnect designs that employ low loss / low noise Physical Contact and or Expanded Beam connectors and fiber optic cable designs
Manufacturer of a broad line of electronic interconnects including High Speed, Micro, Edge Card, Rugged/Power, Cable/Wire/Flex, IP68 Sealed, I/O, and RF Components and Cables. Three categories – High speed (signal integrity), Micro pitch, and Rugged / Power products.
Bulls Eye Test point system for reduced board trace lengths, higher performance and lower cost compared to traditional SMA test systems. The high-density array designs provide up to 4x the high-bandwidth signals in the same real estate as SMA connectors.
520 Park East Boulevard, P.O. Box 1147, New Albany, IN 47151-1147, USA
Amanog many other products they have Raspberry Pi Prototyping Boards, RF/Microwave Microamp Prototyping Boards, Enclosures and Accessories.LED Prototyping Boards, SMT & BGA Adapters, ISA and PCI Products.
See below MB-13 and RF Module PCB designed for rapid prototyping of microwave VCOs using Hittite Microwave devices. The boards are fabricated with high-performance 13 mil thick RO-4350 laminate with RoHS compatible ENIG plating on both the component side and the solid bottom ground plane.
The MicroAmp MH-2 housing will accommodate two MB series circuit board to create a completely shielded 2-port circuits. Boards are available for microwave amplifiers, filters, log detectors, frequency multipliers, dividers, and operational amplifiers that can be cascaded together in a single housing to create more complex circuits.
2303 Camino Ramon, Suite 106 San Ramon, CA 94583 USA